Saturday, September 18, 2010

Halloween Water Bottle Tag Directions

All materials & supplies are Stampin' Up!
Start with a 2 1/4" x 7 3/4" piece of cardstock. Score 2" from each end.

Emboss one end with the Spider Web Embossing Folder (this end gets folded up. The other end is folded down) Cut a 2" square of Wicked Fun Specialty DSP and adhere near the left score line. (as shown above)

Take a piece of 1/8" taffeta old olive ribbon, put a bit of Snail Adhesive in the middle and secure on the back of tag a bit shy of the middle. Bring the ribbon ends around to the front and tie a knot. This will keep the pocket closed.

Use the 1 3/8" circle punch and the 1 3/4" scallop circle punch
to make the opening ring for the tag.

First punch the circle out of Cajun Craze cardstock. Then, holding the scallop punch upside down, punch out the scallop around the circle. (see photo!)

Adhere the scallop ring on the top portion of tag and use
the circle punch to re-cut the circle for the opening.

Ta-da! Use the Tiny Tags stamp set and the Tag punch to create the "Boo!" tag. Adhere tag with a glue dot under the ribbon knot. Add a packet of drink mix, hang on a bottle of water and enjoy!

Note: To add a snack size candy bar like Hershey's or Kitkat, add a 1/4" score line to accommodate the bulkiness. So you would score 2" at one end & then 2" AND 2 1/4" at the other end.
Posted by Picasa

No comments: